Installation Method of Combined Cable Tray Support

Proper cable tray support installation involves planning the route, selecting the right tray type, spacing supports correctly, and securely mounting trays to walls, ceilings, or floors.

Planning and Preparation

Before installation, review approved shop drawings to determine tray layout, length, and routing points. Inspect all materials upon delivery to ensure they match specifications and are free from damage. Store trays horizontally on a flat surface with timber supports at intervals of about one meter, protecting them from moisture and sunlight.

Selecting Tray Type and Size

Choose the appropriate tray type based on cable type, load, and environment. Ladder trays are ideal for power cables due to ventilation and easy cable anchoring, while ventilated troughs provide continuous support for smaller control or instrumentation cables. Calculate tray width and depth according to cable count and spacing to prevent overheating or wasted space.

Support Spacing and Mounting

Supports must be spaced according to tray type and load, typically 1. 5 to 3 meters apart. Use wall brackets, ceiling hangers, or floor supports to secure trays.

Center suspensions can be used for long spans to prevent sagging. Ensure all supports are level and aligned to maintain a straight tray run.

Installation Procedure

Mark the route on walls, ceilings, or floors according to the plan. Install support elements such as brackets or hangers at the designated intervals. Mount cable trays onto supports using appropriate clamps or fasteners.

Ensure trays are level and properly aligned. Connect tray sections with fittings for horizontal or vertical changes, T-pieces, or crossovers. Use covers or barrier strips if required for protection.

Check alignment and stability before pulling cables. For long runs, use rollers to prevent cable damage during installation.

Safety and Compliance

Ensure all installations comply with NEC Article 392 and local electrical codes. Proper bonding and grounding of trays are essential to prevent electrical hazards. Consider environmental factors such as moisture, corrosive chemicals, or mechanical loads when selecting materials, including galvanized steel, stainless steel, or FRP for corrosive environments.

By following these steps, cable tray systems will be secure, organized, and maintainable, providing safe and efficient routing for electrical and communication cables.