Construction of ladder-type cable trays

Ladder-type cable trays are fabricated through precise material selection, cutting, bending, welding, and surface treatment to ensure structural integrity, load capacity, and compliance with industry standards.

Material Selection

Ladder cable trays are typically made from cold-rolled steel for general applications or stainless steel for corrosive environments, while aluminum alloys are used for lightweight and corrosion-resistant applications. The choice of material depends on mechanical strength requirements, environmental conditions, and corrosion resistance. Stainless steel grades like AISI 316L are preferred in highly corrosive or chlorinated environments due to their chromium and molybdenum content.

Cutting and Forming

Materials are cut using CNC laser machines to achieve precise dimensions with minimal finishing. Cutting parameters are adjusted based on material thickness and type. The ladder structure is then formed using CNC bending machines, programmed for exact bend locations, angles, and depths.

Regular calibration ensures consistent production and prevents material fatigue.

Fabrication of Bends and Fittings

Elbows (45° and 90°): Use mandrel benders to maintain inner radius integrity and prevent crimping. Inspect with angle finders for uniformity. Tees and Crosses: Weld intersections with continuous seam welds to enhance structural integrity and reduce stress points.

Ultrasonic testing can detect internal flaws. Reducers and Vertical Bends: Calculate tapering dimensions accurately for smooth transitions.

CN

C tube benders and strain relief are used to prevent cable damage.

Assembly and Quality Assurance

Jigs and fixtures are used to hold parts in place during assembly for accurate alignment. A quality assurance program includes load testing, dimensional verification using coordinate measuring machines (CMM), and traceability of materials to ensure compliance with standards such as BS EN 61537, BS 6946, ASTM, or GBT.

Design Considerations

Rung spacing: Typically 6–18 inches; smaller spacing supports small-diameter control cables, while larger spacing supports power cables. Width: Common widths range from 6 to 48 inches; wider trays may require stronger rungs to maintain load capacity. Airflow and heat dissipation: Ladder trays without covers allow maximum airflow, reducing heat buildup in current-carrying conductors.

Installation: Trays can be mounted on floors, walls, ceilings, or equipment racks, and modular systems allow easy configuration for new or existing cable routes.

Surface Treatment and Corrosion Protection

Steel trays are often pre-galvanized or hot-dip galvanized to prevent corrosion. Aluminum naturally forms a protective oxide layer, while stainless steel relies on its alloy composition for corrosion resistance. Surface treatments enhance durability and longevity, especially in industrial or outdoor environments.

Compliance and Safety

Ladder cable trays are designed to support cables, not personnel, and must be installed according to manufacturer specifications to prevent structural failure or cable damage. Load ratings, bend radii, and support spans must be carefully followed to ensure safe and reliable operation. By following these fabrication steps and design considerations, ladder-type cable trays can provide durable, safe, and efficient cable management solutions for industrial, commercial, and data center applications.